Memory Reset The Pinpad; Initiate Transactions Through Pos Or Through Pinpad - PC-EFTPOS i5100 Manual

8.9

Memory Reset the PINpad

This will reset the PINpad back to factory default settings.
This function is not to be used as there is a risk of permanently damaging the pinpad. If there is an issue
with a pinpad that can not be resolved please contact the CBA Helpdesk on 1800 022 966 for assistance.

This will clear everything from the PINpad. Ensure you have a copy of your terminal and merchant
ID before you continue.

On the i5100 or i3070 terminal, press the top left, top middle, and [CANCEL] keys at the same time
and then release.

The PINpad will start to reset. Press and hold the [CLEAR] key.

The "SSA System Menu" will be displayed.

Using the top left key, scroll down to "AdvancedOptions" and press [OK]

Type "2002" for the password and press [OK]

Using the top left key scroll down to "FormatDFS" and press [OK]

Press the [OK] key again.

The pinpad will start to "chirp". It will take about 30 seconds for the memory reset to complete.
After you have reset the pinpad, you will need to set it back in to
4.0 ).
Configure the terminal
Then perform a TMS Logon
*If you are using the
do the TMS Logon.
8.10

Initiate transactions through POS or through PINpad

You are able to set up the PINpad so that it allows transactions to be processed either through your POS or
through the PINpad (as though it was in standalone mode)

Call the CBA Help Desk on 1800 022 966 (you may need to provide a password which is
"Integrated") and ask them to edit the TMS and disable the "External Display" box

Perform a TMS logon

The standalone ready screen is displayed on the terminal at idle, rather than the CBA logo.

A transaction can now be started on either the POS or the terminal.
To return the PINpad to integrated mode

Call the CBA Help Desk on 1800 022 966 (you may need to provide a password which is
"Integrated") and ask them to edit the TMS and enable the "External Display" box

Perform a TMS logon

The CBA logo is displayed on the terminal at idle, rather than the CBA logo.

The PINpad is now in Integrated mode and a transaction can only be started on the POS
PC-EFTPOS-CBA i5100 / i3070 Guide
(Refer to section 5.0) with the TID and MID.
(refer to section 5.0), followed by a
Internal Modem, make sure you have configured it in the i5100 terminal before you
(refer to section 5.0).
(refer to section 5.0).
PC-EFTPOS mode
Bank Logon
Page 25
(Refer to section
(refer to section 5.0 e)
15/12/2008