Initial I5100 / I3070 Pinpad Setup - PC-EFTPOS i5100 Manual

Initial i5100 / i3070 PINpad Setup

4.
Ingenico 5110 Pinpad:
The CBA i5100 is a combined standalone\integrated PINpad. The bank should deliver the i5110 pinpad
already in integrated mode for PC EFTPOS customers.
Before you install the
EFTPOS software can communicate with it. You need to confirm the pinpad is configured correctly
Is the PINPad set to 'PC EFTPOS Mode'?
Plug in the PSU and power on the 5110 pinpad
 Is the PINpad screen blank or displaying "Connect terminal to register"?
o If YES, this is already in PC-EFTPOS mode.
Proceed to the
o If
NO
1. TERMINAL CONFIG
2. APPLICATION CONFIG
3. STATS & PARAMETERS
 If not, then you will need to enable it. Press [Func] and then [9] and type in your
o Once you are in the hidden menu, press
[1] Terminal Config.,
[3] PC-EFTPOS Mode,
[CHQ] On.
(On some terminals the [CHQ] button will be the Top Left Yellow button).
o
The PINpad will reset and display a blank screen.
Proceed to the
Ingenico i3070 Pinpad:
This pinpad is used for integrated sites only as it does not have an internal modem, or printer to support
standalone mode. The pinpad will always be set up for integrated PC EFTPOS.
The pinpad has an „in-built‟ contactless reader and you should confirm with the merchant if they want this
activated.
PC-EFTPOS-CBA i5100 / i3070 Guide
software, the PINpad needs to be switched to "PC-EFTPOS mode" so that the PC-
software installation
then check to see if the pinpad displays the hidden menu
hidden password*
*To obtain your hidden password, please call either CBA or PC-EFTPOS and have
the last 6 digits of the terminals serial number with you.
software installation
section 5 of this document
section
Page 13 15/12/2008