Ricoh MP 401 spf User Manual page 187

Message
"Cannot print because both the
main and designation (chapter)
sheets are set to the same paper
tray. Press [Job Reset] to cancel
the job."
"Updating the destination list...
Please wait. Specified
destination(s) or sender's name
has been cleared."
"You do not have the privileges
to use this function."
Messages during Direct print from a memory storage device(s)
Message
"Unable to access the
specified memory storage
device."
Causes
The tray selected for other
pages is the same as the one
for slip sheets.
The destination list is being
updated from the network
using Web Image Monitor.
The logged in user name does
not have permission for the
selected function.
Causes
The memory device used
cannot be recognized.
When Messages Are Displayed on the Control Panel
Solutions
Reset the job. Be sure the tray you
select for slip sheets is not
providing paper for other pages.
Wait until the message
disappears. Do not turn off the
main power switch while this
message is displayed. Depending
on the number of destinations to
be updated, there may be some
delay before you can resume
operation. Operations are not
possible while this message is
displayed.
For details about how to set
permissions, see Security Guide
.
Solutions
For details about the recommended
memory devices for the Direct printing
function from memory storage
device(s), contact your service
representative. The USB flash memory
that features password protection or
other security features may not work
normally.
185