Ricoh MP 401 spf User Manual page 183

Status messages
Message
"Hex Dump Mode"
"Suspended job exists."
"Offline"
"Please wait."
"Printing..."
"Ready"
"Resetting job..."
"Setting change..."
"Waitg. for prt.data"
"Job suspended."
"Updating certif..."
Messages displayed on the control panel when using the printer function
• Before turning the main power switch off, see page 46 "Turning On/Off the Power".
In Hex Dump mode, the machine receives data in hexadecimal format.
Press [Job Reset] to cancel Hex Dump mode.
Printing was temporarily stopped by SmartDeviceMonitor for Client.
You can resume printing via [My Job List] in SmartDeviceMonitor for
Client, or via the Web Image Monitor. To resume printing via Web
Image Monitor, ask your system administrator first.
The machine is offline.
• This message might appear for a second or two while the
machine is preparing, performing initial adjustments, or adding
toner. Wait a while.
• The current environmental condition is outside the recommended
temperature range for the machine. Check the optimum
environmental conditions for the machine and move it to a
different location, or leave the machine for a while and allow it to
adapt to the environment.
The machine is printing. Wait a while.
This is the default ready message. The machine is ready for use. No
action is required.
The machine is resetting the print job. Wait until "Ready" appears on
the display panel.
The machine is changing settings. You cannot use the control panel
while this message is displayed. Wait a while.
The machine is waiting for the next data to print. Wait a while.
Printing was temporarily suspended because [Job Operation] or the
[Stop] key was pressed.
The @Remote certificate is being updated. Wait a while.
When Messages Are Displayed on the Control Panel
Status
181