Other Messages - Ricoh MP 401 spf User Manual

10. Troubleshooting
Message
"Exceeded the limit value for
total data size of the
selected files. Cannot select
more files."

Other messages

This section describes likely causes of and possible solutions for the error messages that are printed on
the error logs or reports.
Message
"86: Error"
"91: Error"
"92: Error"
"98: Error"
186
Causes
• The size of the selected
file exceeds 1 GB.
• The total size of the
selected files exceeds
1 GB.
Causes
Parameters of the control
code are invalid.
Printing was canceled by the
auto job cancel function due
to a command error.
Printing was canceled
because [Job Reset] or the
[Stop] key was selected on
the machine's control panel.
The machine could not
access the hard disk
correctly.
Solutions
Files or groups of files larger than 1 GB
cannot be printed.
• When the total size of the multiple
files that are selected exceeds 1
GB, select files separately.
• When the size of selected file
exceeds 1 GB, print by using a
function other than the Direct
printing function from memory
storage device(s).
You cannot select 999 files or more at
the same time.
You cannot select files of different
formats at the same time.
Solutions
Check the print settings.
Check that the data is valid.
Perform the print operation again if
necessary.
Turn off the main power switch, and
then back on again. If the message
appears frequently, contact your
service representative.