Envelopes - Ricoh MP 401 spf User Manual

9. Adding Paper and Toner
Direction of paper
grain
• Select [Thick Paper 1] or [Thick Paper 2] as the paper thickness in [Tray Paper Settings].
• If [Thick Paper 2] is selected, the print speed may change.
• Even if thick paper is loaded as described above, normal operations and print quality might still not
be possible, depending on the paper type.
• Prints might have prominent vertical creases.
• Prints might be noticeably curled. Flatten out prints if they are creased or curled.

Envelopes

This section gives you various details about and recommendations concerning envelopes.
• Do not use window envelopes.
• Fan the envelopes before loading them to separate them and prevent the glue on them from
causing them to stick together.
• Some kinds of envelope might cause misfeeds, wrinkles or print poorly.
• When loading envelopes in the
• Before loading envelopes, press down on them to remove any air from inside, flatten out all four
edges. If they are bent or curled, flatten their leading edges (the edge going into the machine) by
running a pencil or ruler across them.
• When loading envelopes, do not stack paper over the limit mark. If you squeeze extra envelopes
into the bypass tray, misfeeds might occur.
In copier mode
When copying onto envelopes, load them according to the applicable orientation shown below.
146
Paper trays Bypass tray
orientation, load them with flaps closed.