10. Troubleshooting
Messages during Direct print from a memory storage device(s)
Message
"99: Error"
If printing does not start, contact your service representative.
• The contents of errors may be printed on the Configuration Page. Check the Configuration Page in
conjunction with the error log. For details about how to print the Configuration Page, see "List / Test
Print", Print
Messages Displayed When Using the Scanner Function
This section describes likely causes of and possible solutions for the error messages that appear on the
control panel. If a message not described here appears, act according to the message.
Message
"Authentication with the
destination has failed. Check
settings. To check the current
status, press [Comm. Status/
Print]."
"Cannot communicate with
PC. Contact the
administrator."
194
Causes
This data cannot be printed.
The specified data is either
corrupt or not supported by
the Direct printing function
from memory storage
device(s).
.
Causes
The entered user name or
password was invalid.
WSD (Device) protocol or
WSD (Scanner) protocol is
disabled.
Solutions
Check that the data is valid. For details
about the kinds of data supported by
the Direct printing function from
memory storage device(s), see "Direct
Printing from a Memory Storage
Device", Print
.
Solutions
• Check that the user name and
password are correct.
• Check that the ID and password
for the destination folder are
correct.
• A password of 128 or more
characters may not be
recognized.
For details about how to enable or
disable the WSD protocol, see Security
Guide
.