Led And Beeper Indications - Datalogic Magellan 8300 Product Reference Manual

all scan windows are clean
POOR/NO READING
Enter Scanner Diagnostic Mode by
holding the Volume/Tone Push
Button for 4 seconds (until first 3,
and then 6 rapid tones are sounded)
then release. Scan a known-good
bar code.
A good read is
signified by one
flash of the Green
LED and a single
1
beep .
Reset the scanner by
holding down the
Volume/Tone Push Button
for 8 seconds.
If unexpected data
is being sent from
the host to the
scanner, consider
enabling the
programmable
feature Ignore Host
Commands to
debug the system.
4-10
Figure 4-4. Problem Isolation: Poor/No Reading
Have you verified that
and scratch-free?
START
Does the
NO
scanner read
the bar code
satisfactorily
?
YES
Does the
YES
scanner pass
the data to
the POS
?
NO
Go to No Transmit to
Verify programmable
POS flowchart
parameters using the
information and programming
bar codes provided in Section
6. Check bar code symbology
options and other configurable
features.
1
Green and Yellow LEDs and beeper indications are configurable
features. Behavior may vary from that described here.
Before proceeding, verify that
bar code samples presented
to scanner are of good quality
and a symbology the scanner
can read.
Call Tech Support
Does the
YES
scanner read
satisfactorily
?
NO
DONE
Does the
YES
scanner read
DONE
satisfactorily
?
NO
Troubleshoot
the host or call
Tech Support.
TM
Magellan 8300/8400