Datalogic Magellan 8300 Product Reference Manual page 55

NOTE
Product Reference Guide
When power is applied to the unit, the normal indicator sequence is:
• The scanner indicator (top-most, green LED) will be lit (dim)
steadily.
• The 7-segment display will flash the number '8'. indicating initial-
ization.
• If the Selftest detects a problem, the 7-segment display will display a
number code. Refer to
description of failure codes and problem isolation procedures.
Scale calibration may be necessary to obtain a zero reading on
the display on rare occasions.
4. The unit should be permitted to reach thermal equilibrium before
proceeding to the next steps. (Reference the topic
Chapter 1,
in
cooler temperature (such as a storage area) to a warmer environment
(such as a checkstand location), a period of 60 minutes must be
allowed to acclimate the unit to ambient conditions. Once installed
and powered up, a "power-up" warm-up period of 15 minutes must
be allowed before calibrating or performing weighing operations.
These two warm-up periods may run concurrently.
5. Verify that the scanner or scanner/scale passes an operational test by
observing the following:
Chapter 4, Problem
Introduction.) When the unit is moved from a
Installation Overview
Isolation, for a
Warm-Up Time
2-23