Code 39 Start Stop Character Transmission
NOTE
6-268
Enables/disables transmission of Code 39 start and stop characters.
This feature applies only when
tion
is enabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You'll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
CODE 39 START STOP CHARACTER TRANSMISSION = DISABLE
CODE 39 START STOP CHARACTER TRANSMISSION = ENABLE
Code 39 Check Character Calcula-
Magellan
TM
8300/8400