Datalogic Magellan 8300 Product Reference Manual page 123

NOTE
Product Reference Guide
It is recommended that programming sessions be limited to
one feature at a time. Should you make a mistake in the pro-
gramming sequence, it can be difficult to discover where an
error has been made if several features are programmed at
once. Additionally, it can be confusing to determine which fea-
tures may or may not have been successfully set following
such a session.
3. Scan the SWITCH bar code to save any new settings and exit Pro-
gramming Mode. The scanner will sound a beep and reset upon
exiting Programming Mode, and the green LED will return to its
usual state (on steady or off ).
The scanner will exit Programming Mode under the following con-
ditions:
— the programming sequence has been completed or the
SWITCH bar code is scanned
— five minutes have passed without scanning activity. Any
data programmed during the current session will be
ignored
tion previous to initiating the exited session.
— power is disconnected. Disconnecting power during Pro-
gramming Mode, before scanning the SWITCH bar code,
will cause all new settings to be ignored. On power-up, the
scanner will return to previous settings.
4. Maintain a good record of all changes made to ensure that you know
if the original factory settings have been changed.
1. Exception: If an interface bar code had been read while in Programming Mode,
the scanner will operate on the default settings for the new interface.
1
, and the scanner will reset and revert to its condi-
Programming Overview
6-7