Datalogic Magellan 8300 Product Reference Manual page 476

Table A-2. Volume/Tone Push Button Functions (Continued)
PRESS
DURATION
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
4 Seconds
8 Seconds
a. Diagnostics Mode is meant for use by trained systems support personnel. Users should not need to ini-
tiate this function under normal circumstances.
b. Users should not perform scanner resets except under the direction of trained systems support person-
nel.
A-4
FUNCTION
Increments volume
Increments tone
Scanner Diagnostics
a
Mode
b
Resets Scanner
COMMENT
Press the push button momentarily to increase
speaker volume. When the loudest volume is
reached, a repeated press of the push button
cycles volume back to the lowest setting, then vol-
ume increases on subsequent press(es). Four vol-
ume levels are available.
Press the push button for approximately 2 sec-
onds, then release. Each time this is done, the
beeper will sound at one of three tones. Stop when
the desired tone (high, medium or low) is sounded.
This mode allows system support personnel to
troubleshoot problems with the scanner. Upon
entering Scanner Diagnostic Mode, view the 7-
segment display to view Interface Type, Boot-
loader Version Number, Application Version Num-
ber and Configuration File Number. This mode is
used to determine if a scanner can read bar
codes. Press the button for eight seconds or cycle
power to exit Scanner Diagnostics Mode and reset
the scanner.
Only system support personnel should perform a
reset.
TM
Magellan 8300/8400