Label Gone Timeout - Datalogic Magellan 8300 Product Reference Manual

Label Gone Timeout

Product Reference Guide
Specifies the amount of time that data segments are stored by the software
before being discarded if a label has not been successfully decoded during
the current "label in volume session," which is defined as the time between
when the label gone time is first started until the label gone timer expires.
To set the Label Gone Timeout:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You'll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
LABEL GONE TIMEOUT = 50 mS
General Scanner Features
6-21