Table of Contents
Advertisement
3
Select [YES] on the confirmation screen, and press the jog
dial button.
[SD CARD FORMAT OK] is displayed, and the SD memory card is
formatted.
NOTE
@
t Since data that is deleted by formatting cannot be restored, be
sure to check the data before executing formatting.
The card will not be formatted if the following message is displayed
while the jog dial button is pressed:
How to use scene file data
f Settings matching various shooting conditions can be saved as individual scene file numbers.
f The required files can be read in the [CAM02:SCENE FILE] screen of SmartUI.
f The setting values of scene files can also be changed at each item of the setting menu (page 122). After a scene file is changed, it can also be saved
as individual scene file numbers.
f Even when the [VFR] item (option) and the [F.RATE] item (option) are switched on SmartUI during recording, operation is not changed. The operation
changes after recording completes.
Same applies when the [VFR] item or the [F.RATE] item is changed by switching between [F1] to [F6] of scene files.
r Factory settings
[F1]
[F2]: [FLUO.]
[F3]: [SPARK]
[F4]: [B-STR]
[F5]: [CINE V]
[F6]: [CINE D]
NOTE
@
t The [SYSTEM MODE] item is not changed even if a scene file is changed. Set this at each item on the setting menu [SYSTEM SETUP]
screen.
Changing scene file settings
r Renaming scene files
1
Use the <CAM> button to display the [CAM02:SCENE FILE]
screen of SmartUI, and select the scene file to be changed.
2
Select the [NAME EDIT] item on the setting menu [SCENE
FILE] screen, and press the jog dial button.
For details, refer to "Setting menu basic operations" (page 118).
SCENE FILE F3:SPARK
KNEE
MATRIX
SKIN TONE DTL
V DETAIL FREQ
NAME EDIT
PUSH MENU TO RETURN
Chapter 4 Adjustments and Settings for Recording — Handling setting data
File suitable for standard shooting
File suitable for shooting factoring in the characteristics of fluorescent lighting (e.g. indoor shooting)
File suitable for SD shooting with resolution, hue and contrast enhanced
File suitable for shooting with shadow tones extended (e.g. sunsets)
File suitable for film-like shooting with priority given to contrast
File suitable for film-like shooting with priority given to dynamic range
MID
NORM1
OFF
THIN
RETURN
CHANGE
Error message
[SD CARD FORMAT NG NO
CARD]
(No SD memory card is inserted.)
[SD CARD FORMAT NG ERROR]
(The card cannot be formatted.)
[SD CARD FORMAT NG WRITE
PROTECT]
(The card is write-protected.)
[SD CARD FORMAT NG CANNOT
ACCESS]
(The card cannot be accessed.)
3
Select [CHANGE], and press the jog dial button.
SCENE FILE F3:SPARK
KNEE
MATRIX
SKIN TONE DTL
V DETAIL FREQ
NAME EDIT
PUSH MENU TO RETURN
4
When the following screen is displayed, use the jog dial
button to set a 6-character file name.
f Turning the jog dial button switches the character display in the
order of space (m) → alphabet characters (A to Z) → numbers (0 to
9) → symbols (;:<=>?@[¥]^_-./).
– 86 –
Remedy
Insert an SD memory card.
The SD memory card may be
defective.
Replace the card.
Remove the SD memory card and
cancel the protection.
The SD memory card cannot be
accessed.
Wait for accessing to end and then
reformat the card.
MID
NORM1
OFF
THIN
RETURN
CHANGE
Advertisement
Table of Contents
