Table of Contents
Advertisement
1 <HOME> button
2 <COUNTER> button
3 <SETUP> button
4 <HOLD> button
1
Use the <HOME> button to set the SmartUI screen to the
[HOME] screen.
2
Use the <COUNTER> button to set the counter display to
[UB].
3
Use the <SETUP> button to set the SmartUI screen to the
[SET01:TC/UB] screen.
4
Set the [UBG] item to [SET].
5
Set the user bits.
Retention of user bits in memory
User bit settings are automatically saved in memory and are retained even if the power is turned off.
Frame rate information recorded to user bits
If the frame rate value of video information to be shot and recorded based on the frame rate set by each item on the setting menu [SYSTEM SETUP]
screen or by the [FRAME RATE] item (option) is recorded in the user bits, it can be edited the editing device (such as computer editing software).
This information is recorded to VITC UB at all times.
If the setting menu [UB MODE] item is set to [FRM.RATE], it is also recorded to user bits (LTC UB). In playback of clips recorded in native format, the
same values as the frame rate information obtained by playing back recorded user bits are also output as HD SDI output signals or user bits of TC
output from the <TC IN/OUT> terminal.
Frame rate information
The frame rate and video pull-down menu are linked to the time code and user bits as follows:
Checking information for the 6 digits at right Fixed
Chapter 4 Adjustments and Settings for Recording — Setting the time data
Sequence No.
24P, 24PA: 0 - 4
Other than the above: Fixed
at F
4 2
HOLD
TC
MEDIA
E
BATT
E
/REW
Item name
[→]
[+]
[−]
[RST]
6
Press [UBG] to apply the user bit setting values and end
setting of user bits.
NOTE
@
t Newly set values are invalid if the screen is switched without
pressing [UBG].
7
Select [USER] at the [UB MODE] item on the setting menu
[RECORDING SETUP] screen.
For details, refer to "Setting menu basic operations" (page 118).
Media management information
value
Updated frame flag, valid frame flag
REC mark
Camera video mode
Example)
60i 600
60P 608
30P 308
24P 248
24PA 24C
24PN 24C
P
9
P
D
– 67 –
COUNTER
RESET MONITOR SEL
LIGHT
NDF SLABE P -REC
CAM
0
AUDIO
-10
CH1
A
-18
F
-20
3
-30
SET UP
CH2
dB
F
1
2
HOME
STOP
FF/
PLAY/PAUSE
1
Description
The digit to be set (displayed inverted) moves to the
right.
The value of the inverted digit is incremented by one.
The value of the inverted digit is decremented by
one.
The values of all digits are reset to 0.
(Shooting)
(720P/30PN or 60P VFR)
(720P/24PN VFR shooting)
Advertisement
Table of Contents
