Table of Contents
Advertisement
Chapter 9 Connecting to External Devices — Connection through the <USB2.0> terminal
10
11
12
Press the <EXIT> button to return to the previous screen.
For [FAT]
1
2
3
4
5
6
Press the <SET> button to switch the screen.
Press the <EXIT> button to return to the previous screen.
1 [PARTITION]
The hard disk drive type is displayed. The available functions differ
depending on the hard disk drive type.
Hard disk
Features
drive type
A special format to enable
fast write/write-back on a
card basis.
[TYPE S]
Perform [FORMAT] on
the camera to obtain this
format.
Indicates P2 STORE.
[P2STORE]
No writing operation is
allowed.
A hard disk drive that the
heading basic partition
is FAT16 or FAT32 in a
[FAT]
computer and that requires
the CONTENTS directory in
the partition root.
Hard disk drive other than
the above.
f Displayed when the
root does not have the
[OTHER]
CONTENTS directory, or
when the file system is not
FAT16 or FAT32, such as
NTFS.
2 [VENDOR]
3 [MODEL]
4 [SIZE]
5 [USED]
6 [FREE CAP.]
7 Partition number
8 [MODEL]
9 [DATE]/[TIME]
10 [SERIAL]
Available functions
11 [VERIFY]
Thumbnail display, write/
write back on a card
basis, write-back on a
clip basis, format
Thumbnail display, write
back on a card basis,
write back on a clip basis
Thumbnail display, write
back on a clip basis,
format
f After formatting, it can
be used as the [TYPE
S] hard disk drive.
format
12 [NAME]
f After formatting, it can
be used as the [TYPE
S] hard disk drive.
– 148 –
The vendor name of the hard disk drive is displayed.
The model name of the hard disk drive is displayed.
The total space of the hard disk drive is displayed.
The usage capacity of the hard disk drive is displayed at the upper
section. (Unit: GB)
The number of P2 cards saved on the hard disk drive is displayed at
the bottom section.
The free space in the hard disk drive (GB) is displayed.
The partition number of the hard disk drive is displayed.
The partition number is on a single P2 card basis.
NOTE
@
t Up to ten numbers are displayed in the screen. If there are
more than 11 partitions, use the cursor buttons ({) to scroll
down.
t Up to 23 P2 cards can be recorded to the hard disk drive.
The model name of the P2 card on the recording source is displayed.
NOTE
@
t Press the cursor buttons (I) to switch to [PARTITION NAME].
Use the cursor buttons (Y) to return to the model name display.
Date and time when the data in the partition is saved.
The serial number of the P2 card on the recording source is
displayed.
The setting and result of verification are displayed.
[ON/FINISHED] Verification was performed and the verification result
matches.
[ON/FAILED]
Verification was performed but the verification result
does not match.
[OFF]
Verification was not performed.
[----]
No verification information available.
NOTE
@
t Clips after the 1001st clip are not displayed even if the hard disk
drive type is FAT.
t For the FAT formatted hard disk drives, only the information in
the initial partition is displayed.
t If there is an invalid partition in P2 STORE (AJ-PCS060G), the
partition information is displayed in gray.
[PARTITION NAME] is displayed.
A [PARTITION NAME] can be entered from the software keyboard by
selecting [CHANGE PARTITION NAME] in the [OPERATION] menu
while the thumbnails are displayed. (Up to 20 characters)
Advertisement
Table of Contents
