Table of Contents
Advertisement
a: <ND FILTER> dial
b: <REC> button
c: Shutter switch
d: <AUTO W/B BAL> switch
e: <WHITE BAL> switch
1
Select a filter by the <ND FILTER> dial according to the light
conditions.
2
Operate the <WHITE BAL> switch.
r When the white balance is already saved in memory:
f Set the <WHITE BAL> switch to <A> or <B>.
r When neither white or black balance is saved in memory and
you have no time to adjust the white balance:
f Set the <WHITE BAL> switch to <PRST>.
f The value can be changed to 3200 K, 5600 K, and the user-
specified variable value by pushing the <AUTO W/B BAL> switch
towards the <AWB> side, and pushing the <AUTO W/B BAL>
switch towards the <AWB> side again while the color temperature is
displayed. The variable value can be set at SmartUI. (page 140)
Standard recording
Pressing the <REC> button starts recording of video and sound on the P2 card.
A group of data consisting of video and sound generated by a single shooting action, together with additional information, is called a "clip".
NOTE
@
t In the following cases, it may take time to complete writing to the P2 card.
Pressing the <REC> button does not accept operations immediately.
- When short-burst recording is stopped
- When stopping recording immediately after recording to two P2 cards
Chapter 3 Recording and Playback — Basic procedures
a
b
c d
<REC> button
– 36 –
b
e
r To adjust the white balance on the spot:
f Select a filter matched to the lighting conditions, set the <WHITE
BAL> switch to <A> or <B>, shoot a white test subject, and adjust
the white balance by the following steps.
1) Press the <AUTO W/B BAL> switch towards the <AWB> side to
adjust the white balance. (page 53)
2) Set the <AUTO W/B BAL> switch towards the <ABB> side to
adjust the black balance. (page 55)
3) Press the <AUTO W/B BAL> switch towards the <AWB> side to
adjust the white balance again.
3
Point the camera at your subject and adjust the focus and
zoom.
4
When using the electronic shutter, set the shutter speed and
shutter mode. (page 56)
5
Press the <REC> button to start recording.
6
To stop recording, press the <REC> button again.
NOTE
@
t When highly bright subjects (e.g. sun or lighting) are shot, the
periphery of the subject might be colored.
Advertisement
Table of Contents
