Table of Contents
Advertisement
Preventing accidental erasure
To prevent the content of a P2 card from being accidentally erased, set the write-protect switch on the P2 card to the Protect position.
P2 card access LEDs and status of P2 cards
P2 card access LED
Is illuminated green
Is illuminated orange
Flashing orange
Flashing orange rapidly
Flashing green slowly
Off
* The mode check is displayed on the viewfinder screen. For details, refer to "Viewfinder status display" (page 72).
P2 card recording time
r P2 cards supported on the camera
Optional P2 cards with a capacity of 4 GB to 64 GB can be used with the camera. (As of September, 2012)
NOTE
@
t AJ-P2C002SG (2 GB) cards cannot be used.
t The driver installed on the camera may be required to be updated depending on the type of P2 card. (page 160)
t For the latest information not available in the Operating Instructions, visit the support desk at the following website:
http://pro-av.panasonic.net/
r P2 card recording times
(When a 64 GB card is used)
System mode
HD (1080i, 720P)
SD (480i)
NOTE
@
t The above table shows values for regular recording. With native recording, even longer recording times are available depending on the
system mode. (page 48)
t In the case of 32 GB P2 cards, the recording time becomes 1/2 of the above recording times, in the case of 16 GB P2 cards, the recording
time becomes 1/4, and in the case of 8 GB P2 cards, the recording time becomes 1/8.
t Indicated capacities include management and other area, so the space available for recording is less than the values in the table above.
Chapter 3 Recording and Playback — P2 card
Write-protect switch
Recording possible
Reading/writing both possible
Reading/writing both possible. The card is currently
Recording target
recording target (including loop recording, interval
recording, one-shot recording).
Accessing card
Reading/writing are currently being performed.
The card is being
The P2 card is being recognized.
recognized.
There is no free space on the P2 card. The card can only
Card full
be read.
The write-protect switch on the P2 card is at the Protect
Write protect
position. The card can only be read.
This card cannot be used on the camera. Replace the
Card not supported
card.
Format error
The P2 card is not properly formatted. Reformat the card. [FORMAT ERROR]
No P2 card is inserted. The card is waiting to be
No card
recognized.
Recording format (codec)
AVC-I 100
DVCPRO HD
AVC-I 50
DVCPRO50
DVCPRO
DV
NOTE
@
t Write-protect switch can be switched while the card is being
accessed (during recording or playback), but does not take effect
until accessing of the card stops.
P2 card status
Recording time
Approx. 64 min
Approx. 128 min
Approx. 128 min
Approx. 256 min
– 33 –
Mode check display*
[ACTIVE]
[ACTIVE]
[ACCESSING]
[INFO READING]
[FULL]
[PROTECTED]
[NOT SUPPORTED]
[NO CARD]
Advertisement
Table of Contents
