Table of Contents
Advertisement
Chapter 4 Adjustments and Settings for Recording — Adjusting the white and black balance
Adjusting the black balance
Black balance must be adjusted in the following instances:
f When the camera is used for the first time
f When the camera has not been used for a long time
f When the ambient temperature has changed considerably
f When the gain switchover value has been changed
f When the [SYSTEM MODE] and [REC FORMAT] items on the setting menu [SYSTEM SETUP] screen has been changed
To shoot optimum video, we recommend adjusting the black balance immediately before shooting.
a: <AUTO W/B BAL> switch
Used to execute the automatic black balance.
b: <OUTPUT> switch
Set this switch to <CAM>.
1
Set the <AUTO W/B BAL> switch towards <ABB> and then
release it.
The switch returns to the central position with the black balance
automatically adjusted.
2
During an adjustment, the following message is displayed on
the viewfinder screen:
3
The adjustment is complete in several seconds, and the
following message is displayed:
The adjusted value is automatically stored in memory.
NOTE
@
t Make sure that the lens connector is connected and that the lens
aperture is in the close mode.
t During black balance adjustment, the aperture is set to
automatically shut out light. Note, however, that [ABB NG] is
sometimes displayed when light is not shut out due, for example, to
the lens connector becoming disconnected.
t During recording, black balance cannot be adjusted.
t During the automatic black balance execution, recording to the P2
card is not performed by pressing the <REC> button.
a
ABB ACTIVE
ABB END
b
– 55 –
Advertisement
Table of Contents
