Table of Contents
Advertisement
3
Place the flange back adjustment chart approximately 3 m
from the lens and adjust the lighting on the chart to obtain
an appropriate image output level.
If the image level is too high, use the filters or the shutter.
4
Loosen the F.f (Flange focus) ring clamping screw.
NOTE
@
t F.b (Flange back) may be indicated on some lenses.
5
Set the zoom ring to the telephoto position, either manually
or by electric drive.
White shading compensation
Three optionally adjustable data items [USER1], [USER2], and [USER3] can be used for white shading compensation with the camera. Set these data
items from the [SHADING SELECT] item on the setting menu [LENS SETUP] screen. Shading compensation is not performed when set it to [OFF].
NOTE
@
t When white shading adjustment is performed while image is being disturbed due to the generator lock, adjustment may not be performed
correctly. Try white shading adjustment again after the image returns to normal.
Selecting white shading data
1
Select the [SHADING SELECT] item on the setting menu
[LENS SETUP] screen, and press the jog dial button.
For details, refer to "Setting menu basic operations" (page 118).
LENS SETUP
SHADING SELECT
SHADING(USER)
CAC
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
IRIS GAIN
PUSH MENU TO RETURN
2
Use the jog dial button to select any one of [USER1],
[USER2], [USER3], or [OFF], and press the jog dial button.
Adjusting the white shading
NOTE
@
t Coloring may occur in the vertical direction near where the lens aperture is open (OPEN) even when the white shading has been adjusted,
but this is something that is inherent to optical systems and is therefore not indicative of a malfunction.
1
Set the camera for adjustment.
1) Mount the lens on the camera.
f Make sure to connect the lens cable.
2) Set the shutter switch to OFF and the gain to 0 dB.
3) If the lens is equipped with extender function, release the extender
function.
4) Check that either [USER1], [USER2], or [USER3] is set with the
[SHADING SELECT] item on the setting menu [LENS SETUP]
screen.
5) Select [EXECUTE] at the [SHADING (USER)] item, and press the
jog dial button.
Chapter 5 Preparation — Mounting and adjusting the lens
OFF
>>>
ON
>>>
>>>
>>>
>>>
LENS
– 94 –
6
Aim the lens at the flange back adjustment chart and turn the
distance ring to bring the chart into focus.
7
Set the zoom ring to the wide-angle position and turn the F.f
(Flange focus) ring to bring the chart into focus.
At this time, do not move the distance ring.
8
Repeat steps 5 to 7 until the lens is in focus at both the
telephoto and wide-angle positions.
9
Firmly tighten the F.f (Flange focus) ring clamping screw.
f To perform white shading adjustment, select either [USER1],
[USER2], or [USER3].
f With factory settings, no data is stored in [USER1], [USER2], and
[USER3].
LENS SETUP
SHADING SELECT
SHADING(USER)
CAC
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
IRIS GAIN
PUSH MENU TO RETURN
USER1
USER2
USER3
OFF
>>>
>>>
>>>
LENS
Advertisement
Table of Contents
