Panasonic ag-hpx600p Operating Instructions Manual page 112

f A software keyboard screen is displayed, allowing you to modify the
setting.
Setting whether to record the uploaded metadata
From the thumbnail menu, select [META DATA] → [RECORD] item, and set it to [ON]/[OFF]. This item is set to [OFF] in the factory settings.
Selecting the [USER CLIP NAME] recording method
From the thumbnail menu, select [META DATA] → [USER CLIP NAME], and select the recording method of [USER CLIP NAME] from either [TYPE1] or
[TYPE2].
r [TYPE1] (factory setting)
When clip metadata has been loaded
When no clip metadata has been loaded, or when setting disables recording of loaded clip
metadata
r [TYPE2]
When clip metadata has been loaded
When no clip metadata has been loaded, or when setting disables recording of loaded clip
metadata
* The [COUNT] value is indicated as a four digit number.
The [COUNT] value is incremented each time a new clip is captured if clip metadata has been read in and [TYPE2] has been selected as the recording method.
The [COUNT] value can be reset using the following method.
Select [META DATA] → [PROPERTY] from the thumbnail menu, and select the [USER CLIP NAME] item to display the following screen. Move the cursor over
[COUNT RESET], and press the <SET> button to reset the [COUNT] value to 1.
NOTE
@
t When a P2 card with a memory capacity of 8 GB or more is used in the camera, and a one-time continuous recording exceeds the
prescribed duration (DVCPRO HD and AVC-Intra 100: approximately five minutes; DVCPRO50 and AVC-Intra 50: approximately ten minutes;
DVCPRO or for DV: approximately 20 minutes), or when a one-time recording extends over more than one P2 card, the recording concerned
will automatically be recorded as a separate clip. At this time, each clip will be provided with its own [COUNT] value.
r Example of recording ([DVCPROHD]) a clip on a single P2 card
Chapter 6 Thumbnail Operations for Clips — Thumbnail operations
Status of clip metadata
Status of clip metadata
Start recording
Recording duration = Approx. 7 min.
Clip 1
[COUNT] value
= 0001
Approx. 5 min.
f While holding down the <SHIFT> button, press the cursor up or
down button (`/{) to move to the start or end of the content to
change.
Uploaded data
Same as [GLOBAL CLIP ID] (UMID data)
Uploaded data + [COUNT] value*
Same as [CLIP NAME]
Recording pause
Clip 2
[COUNT] value
= 0002
Approx. 2 min.
– 112 –
[USER CLIP NAME] to be recorded
[USER CLIP NAME] to be recorded