Preventing Accidental Erasure; P2 Card Access Leds And Status Of P2 Cards; P2 Card Recording Time - Panasonic AJ-PX800G Operating Instructions Manual

t If a P2 card is inserted into another slot during playback, the inserted card is not recognized and the P2 card access LED does not light up. The P2
card will be recognized when playback ends.
t Even if a P2 card is inserted in a vacant card slot during recording, the P2 card may not be recognized immediately in the following instance:
- Immediately after a pre-recording
t The P2 card access LED can be set to continuously off in the main menu → [OTHER FUNCTIONS] → [ACCESS LED]. In this case, turn off the power
before removing the card, or after the card is inserted or after operation (recording, playback, etc.) has stopped, and wait for the charging to complete
before removing the card.

Preventing accidental erasure

In order to prevent erasing the recorded contents of the P2 card by mistake, turn the write protect switch on the P2 card to the Protect side (or the LOCK
side).
@
NOTE
t Write-protect switch can be switched while the card is being accessed (during recording or playback), but does not take effect until accessing of the
card stops.

P2 card access LEDs and status of P2 cards

P2 card access LED
Is illuminated green
Is illuminated orange
Flashing orange
Flashing orange rapidly
Flashing green slowly
Off
* Mode check is displayed in the viewinder. For details, refer to "Screen status display" (page 152).

P2 card recording time

r P2 cards supported on the camera
Optional P2 memory cards and microP2 memory cards with a capacity of 4 GB to 64 GB can be used with the camera. (As of September 2014)
@
NOTE
t AJ-P2C002SG (2 GB) cards cannot be used.
t The driver installed on the camera may be required to be updated depending on the type of P2 card. (page 199)
t Refer to our support desk at the following website for the latest information not included in these operating instructions.
http://pro-av.panasonic.net/
Chapter 3 Preparation — P2 card
Write-protect switch
Recording possible Reading/writing are both possible.
Reading/writing are both possible. The card is currently
Recording target
the recording target (including loop recording).
Accessing card Reading/writing are currently being performed.
The card is being
The P2 card is being recognized.
recognized.
There is no free space on the P2 card. Reading only is
Card full
possible.
The write-protect switch on the P2 card is at the Protect
Write protect
position. Reading only is possible.
Recording is not possible by the currently set recording
format since the SD memory card, etc. is inserted. To
Unrecordable card
record the card, change the recording format or use a
P2 card.
This card cannot be used on the camera. Replace the
Card not supported
card.
The P2 card is not properly formatted. Reformat the
Illegal format
card.
The P2 card is not inserted. The card is waiting to be
No card
recognized.
This microP2 memory card cannot be authenticated.
Select the main menu → [CLIP] → [AUTHENTICATE],
Unauthenticated card and enter the password.
For details, refer to "Manual CPS authentication"
(page 113).
The P2 card cannot be accessed since the mode is the
USB non-access
USB device mode.
P2 card status
– 43 –
Write-protect switch
Mode check display*
[ACTIVE]
[ACTIVE]
[ACCESSING]
[INFO READING]
[FULL]
[PROTECTED]
[REC IMPOSSIBLE]
[NOT SUPPORTED]
[FORMAT ERROR]
[NO CARD]
[AUTH NG]
No display