Table of Contents
Advertisement
DINION 5100i IR
Target
Select the target account for JPEG posting.
Notice!
i
You must configure an account in order to have functionality for Image Posting. Click on
Configure accounts to do so.
Click Set to apply the changes.
4.5.8
SD Card Status
This section identifies the details about the SD card installed in the device:
–
–
–
–
–
For non-industrial SD cards, the lifespan options are not available.
Lifespan check
When checked, the Lifespan status is shown in the details of the SD cards.
Lifespan alarm
Set the alarm warning to a defined percentage of the lifespan. The alarms can be given as:
–
–
–
If a SD card is not installed, 'SD card not found' is shown.
Notice!
i
Bosch recommends the use of industrial micro SD cards with health monitoring.
4.6
Alarm
4.6.1
Alarm Connections
In the event of an alarm, the unit can automatically connect to a pre-defined IP address. The
unit can contact up to ten IP addresses in the order listed until a connection is made.
Connect on alarm
Select On so that the unit automatically connects to a pre-defined IP address in the event of
an alarm.
Select Follows input 1 so that the unit maintains the connection for as long as an alarm exists
on alarm input 1.
Auto-connect
Select On to automatically re-establish a connection to one of the previously specified IP
addresses after each reboot, connection breakdown, or network failure.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote locations one after the other in the numbered sequence until a
connection is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Bosch Security Systems B.V.
Manufacturer
Product
Size
State
Lifespan.
An audio alarm
An e-mail
A warning through the Video Management System
User manual
Configuration | en
2023-08 | V01 | F.01U.393.997
41
Advertisement
Table of Contents
