Table of Contents
Advertisement
12
en | Preparing for installation
4.3
Preparation
Before installation, prepare and plan the installation process and materials needed.
Pre-requisites
Remove the components from the box. Make sure that all parts are included and are not
damaged.
The necessary material and equipment:
–
–
–
–
4.4
In-box configuration
In-box configuration of the camera can be done via a wired connection with the camera still
inside the box.
1.
2.
For more detail about the Project Assistant app, refer to Commissioning, page 29.
Notice!
i
The provided patch cable is only intended for in-box configuration. Dispose of the patch
cable after the in-box configuration is successfully completed.
4.5
Wiring
2023-08 | V02 | DOC
3
Installer UX labels
Appropriate size power drill.
Screwdriver for TR20 bit, or use a torque wrench TR20 hex key.
microSD card (optional)
Note: Bosch recommends the use of industrial microSD cards with health monitoring.
Wireless installation dongle for wireless commissioning (optional).
Connect a network cable with PoE, and wait 1 minute for the camera to power up.
Connect and configure the camera via the wired network by using the web interface ,
the Project Assistant app or the Configuration Manager.
5
4
6
3
7
1 10-pin I/O connector
3 Grommet (IP66 or IP67)
2 Safety wire anchor
4 Punch down network connector
Installation manual
DINION 7100i IR
8
1
2
Bosch Security Systems B.V.
Advertisement
Table of Contents
