Chevrolet 1988 Light Duty Truck Repair Manual page 95

A. Seal Seat
R etainer Ring
J 33026
Figure 22— Removing or Installing the Shaft Lip
Seal Retaining Ring
• Insert J 23128-A into the shaft lip seal, tighten
and remove lip seal.
4. O-Ring seal using J 9553-01 (figure 24).
L»
Inspect
Make sure the com pressor neck area is clean.
All parts. Replace as necessary.
Figure 23 — Removing or Installing the Shaft
Tip Seal
HR-6 AIR CONDITIONING COMPRESSOR 1B5-9
J 5403
F-04524
+4- Install or C o n n e c t (F ig u res 4 and 25)
Tools Required:
• Dip the new O-ring seal in clean 525 viscosity
refrigerant oil.
• J 34614 onto the shaft (20).
1. O-ring seal using J 33011 (figure 25).
2. Shaft lip seal using J 23128-A (figure 23).
J 33011 O-Ring Seal Installer
J 23128-A Seal Seat Remover and Installer.
J 34614 Shaft Seal Protector
J 5403 Snap Ring Pliers
• Insert J 33011 into the com pressor neck until
the installer " bottom s."
• Lower the movable slide of J 33011, releasing
the O-ring seal into the lower groove.
• Rotate J 33011 to seat the O-ring seal and
remove J 33011.
• Dip the shaft lip seal in clean 525 viscosity
refrigerant oil and install shaft lip seal on
J 23128-A.