Chevrolet 1988 Light Duty Truck Repair Manual page 21

Install J 9395 over the end of the com pressor
shaft (38) (figure 7).
Im p o rta n t
• Use J 9395 puller pilot to prevent internal
d a m a g e to th e
rem oving the pulley. Do not use the
pulley directly against the end of the
shaft.
Place J 8433 over J 9395 for the regular
V-groove pulley.
Figure 7— Removing the Pulley and Bearing
A-6 AIR CONDITIONING COMPRESSOR 1B1-5
c o m p r e s s o r w h e n
Figure 8— Removing the Pulley and Bearing
Retainer Ring
• Place J 24092 over J 9395 for the multi-groove
pulley.
• Turn the screw on J 8433 to remove the pulley
6
( ).
Im p o rta n t
• W hen using J 24092, the puller arms
must extend around to the rear side of
the pulley. Do not attem pt to pull the
pulley off by engaging the puller arms in
a multi-groove pulley.
Bearing (5) from the pulley (6) (figure 8).
• Remove the retaining ring (3).
• Pulley (6) to J 21352 (figure 9).
• Drive the bearing 95) from the pulley (6) with
J 9398 and J 8092.
Install or C o n n e c t (F ig u re s 1 and 10)
Tools Required:
J 6435 Snap Ring Pliers
J 8092 Driver Handle
Figure 9 — Removing the Bearing from the Pulley