SAGINAW INTEGRAL POWER STEERING GEAR—
NOTICE: R e p a ir the s te e rin g g e a r in a clean,
d u st-fre e lo c a tio n , u s in g cle a n to o ls a nd e q u ip -
m ie n t. D irt o r g rit w ill dam age the m a c h in e d
surface s an d re s u lt in leakage o r dam age to the
s te e rin g g e a r assem bly.
If broken com ponents or foreign materials are found
during disassem bly of the gear the hydraulic system
should be disassem bled, inspected, cleaned and flushed
before servicing is complete.
CK (GMT 400)
Service inform ation is shown in figures 24, 25, 26, 27
and 28.
The ball nut and control rings (seals) generally need not
be replaced unless cut or damaged. If cut or damaged,
inspect all mating parts for burrs, cracks, scratches, or
damage. Replace or repair as needed.
In some instances, " power steering flu id " will be speci
fied to lubricate parts upon assembly. In these cases, GM
Power Steering Fluid, part no. 1050017 or equivalent
should be used. DO NOT use brake fluid, autom atic trans
mission fluid, or other non-approved fluids.
POWER STEERING 3B3-9