Clutch Coil And Housing Assembly R Eplacem Ent - Chevrolet 1988 Light Duty Truck Repair Manual

1B1-6 A-6 AIR CONDITIONING COMPRESSOR
J 9481-A Pulley Bearing and Pulley Installer
1. B e aring (5) to the p u lle y (6) w ith J 8092 and
J 9481-A (figure 10).
2. Retainer ring (4) to the pulley (6).
3. Pulley (6) and bearing (5) to shaft (38) with J 8092
and J 9481-A.
4. Retainer ring (4) to pulley (6) and bearing (5).
5. Pulley retainer ring (3) with J 0435.
6. Clutch plate and hub assembly(2).
• Refer to " Clutch Rotor and Hub Assembly
R eplacem ent."
CLUTCH COIL AND HOUSIONG
ASSEMBLY REPLACEMENT
R em o ve or D is c o n n e ct (F ig u re 1)
Tool Required:
J 6435 Snap Ring Pliers
Clutch plate and hub assembly (2).
Pulley (6).
Mark or scribe the location of the clutch coil (8) to
terminal on the com pressor front head (16).
Clutch coil assembly (8).
• Coil housing retaining ring (7) with J 6435.
• Using a large screwdriver or small pry bar, pry
the clutch coil away from the front head. If
n e c e s s a ry , h a n d
screwdriver handle or pry bar to break the
adhesive bond of the clutch coil to the front
head.
)Q I
Clean
Adhesive from the coil by scraping with a putty
knife.
Remove any adhesive around the three locator hole
areas of the front head and around the three clutch
coil locator protrusions at the rear of the clutch coil
housing.
Use a suitable solvent to clean the coil.
im p a c t a b lo w to th e
Im p o rtan t
After applying Loctite Depend, Loctite Trim
and Detail Adhesive or equivalent to the coil,
install all the clutch parts to the compressor.
Allow 30 minutes for the adhesive to set.
+ 4-
Install or C o n n ect (F ig u res 11 and 12)
Tool Required:
J 6435 Snap Ring Pliers
1. Adhesive to the clutch coil (8) (figure 11}