Table of Contents
Advertisement
All seats occupied, boot loaded
Driver seat occupied, boot loaded
Xenon headlight
The Xenon bulbs adapt automatically to the load and driving state of the vehi-
cle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Xenon headlights do not have a manual headlight range adjustment
control.
WARNING
Always adjust the headlight range control to meet the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
The light switch is in position or and the ignition is turned off, the low
■
beam is switched off automatically
switched off when the ignition key is removed, for vehicles with the KESSY
system after switching off the ignition and opening the driver's door.
If there is a fault in the light switch, the low beam comes on automatically.
■
Daylight running lights (DAY LIGHT)
Read and observe
on page 67 first.
The daytime running lights light up the area in front of and to the rear of the
vehicle (only applicable for some countries).
The lights are switched on automatically if the following conditions are met.
The light switch is in the position or .
The ignition is switched on.
WARNING
Always switch on the low beam when visibility is poor.
1)
Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page
71.
68
Using the system
and the status light is lit. The side light is
1)
Turn signal and main beam
Read and observe
on page 67 first.
Operating lever positions
» Fig. 55
Activate right turn signal light - indicator light flashes in the instrument
A
cluster
Activate left turn signal light - indicator light flashes in the instrument
B
cluster
Depending on equipment (spring-tensioned position):
C
▶
Switch on main beam – indicator light lights up in the instrument cluster
▶
Activate headlamp assistant
Depending on equipment (spring-tensioned position):
D
▶
Switch off main beam / headlight flasher on (spring-tensioned position)
▶
Deactivate headlamp assistant / activate headlight flasher (spring-ten-
sioned position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
"Convenience turn signal"
When the control lever is lightly pressed to the pressure point
the respective turn-signal lamp flashes three times.
Fig. 55
Operating lever: Turn signal and
main beam operation
» page 72
or
A
then
B
Advertisement
Chapters
Table of Contents
