Installation - Triumph Tiger Service Manual

Installation
1. Thoroughly clean the liner removing all traces of old
silicone sealer.
2. Remove all traces of sealer from the crankcase
bores.
3. Apply silicone sealer to the liner to crankcase
mating face.
1. Liner
2. Sealer Area
4. Fit each liner over the piston using a gentle rocking
motion to allow compression of the piston rings.
2
jadg
1. Piston
2. Liner
6.23
CRANKSHAFT/RODS/PISTONS 6
NOTE:
• The liners have a chamfer at the bottom of the
bore enabling fitting of the piston without need
for a piston ring compressor.
~
CAUTION: Fit each liner over whichever
~
piston is at TOC. When turning the
engine, do not allow the pistons to contact the
inside of the crankcase and also do not allow fitted
liners to lift off the crankcase base.
5. Continue fitting each liner in turn until all are fitted
and sealed.
NOTE:
•
When the liners have been fitted, they should
not be disturbed. If it is necessary to remove the
liner after fitting, the sealer must be re-applied.