Installation; Input And Output Shafts Assemblies; Removal - Triumph Speed Triple Service Manual

Transmission
i
Input and Output Shafts
Assemblies
Removal
1.
~ e m o v e the engine from the frame (see page
9-
2).
2.
Separate the two halves of the crank case (see
page 5-4).
3.
Lift the input and output shaft assemblies out of
the upper crankcase.
Installation
1. Place the output shaft in position in the
crankcase.
4. Ensure the dowel in the output shaft needle roller
bearing is positioned to locate in the hole
provided in the upper crankcase.
2 .
Ensure the retaining ring on the bearing locates
1. Roller bearing
1
in the groove provided in the crankcase.
2. Dowel
3. Ensure the output shaft seal aligns with its
5. Ensure the output shaft seal aligns with its
recess in the crankcase.
recess in the crankcase.
\
)
1. Groove in crankcase
2. Retaining ring
3. Seal
Repeat steps 1 to 3 for the input shaft and
ensure that both sets of gear mesh correctly and
that the half-circlip is correctly located and is not
accidentally omitted.
Service Manual
-
Speed Triple
7.1 1