Triumph Tiger Service Manual page 91

(
( "I
17. Locate and secure the oil cooler to the lower
mounting bracket. Tighten the fixing to 9 Nm.
18. Incorporating new sealing washers to both sides of
the connections, fit and tighten the oil cooler pipes
to the sump. Tighten the connections to 25 Nm.
19. Using new seals at the cylinder head end, refit the
exhaust system as described in the fuel system
section.
1. Downpipe to Head Fixings
2. Collector Box Mounting
3. Silencer Mounting
20. Position the radiator/thermostat assembly to the
lower radiator mounting brackets.
1. Radiator Fixings
2. Radiator
3. Thermostat Housing
4. Top Hose
5. Bottom Hose
21. Locate the top and bottom hoses and tighten the
, clips.
)
6.9
CRANKSHAFT/RODS/PISTONS 6
22. Tighten the radiator upper mounting bolts to 9 Nm
and the thermostat housing fixing to 5 Nm.
23. Reconnect the cooling fan.
24. Refit the coolant temperature sensor and retain with
the clip.
25. Refit and tighten the upper oil cooler fixing. Tighten
the fixing to 9 Nm.
26. Refit the left hand control plate assembly. Tighten
the larger fixings to 27 Nm and the smaller fixing to 9
Nm.
1. Control Plate
2. Larger Fixings
3. Smaller Fixing
27. Refit the right hand control plate assembly ensuring
that the rear brake master cylinder and hoses are
correctly positioned. Tighten the fixings to 27 Nm.
28. Refit the brake pedal to the control plate and tighten
the pivot bolt to 27 Nm. Check thatthe pedal moves
freely and rectify any tightness as necessary.