Triumph Tiger Service Manual page 90

6 CRANKSHAFT/RODS/PISTONS
NOTE:
•
To accurately adjust the clutch cable, It Is
essential thatthe knuckle guard is first removed
fro In the clutch lever, and the pivot bolt
temporarily refitted.
10. Operate the clutch lever several times and recheck
the amount of free-play present.
11. Set the final adjustment of the cable to give 0.4-0.8
mm of free-play at the lever by turning the adjuster
nut and locknut at the lever end. Tighten the lock
ring.
kace
1. Clutch Lever
2. Correct Setting, 0.4-0.8 mm
12. Refit the throttle cable to the throttle bodies. When
correctly set, the throttle must have 2-3 mm of free
play at the throttle twist grip. If there is more or less
than 2-3 mm offree-play present, the throttle cable
must be adjusted.
1. Throttle Twist Grip
2.2-3 mm
6.8
A
WARNING: Operation of the motorcycle
with an incorrectly adjusted, incorrectly
routed, sticking or damaged throttle cable could
interfere with the operation of the brakes,clutch or
the throttle itself. Any of these conditions could
result in loss of control of the motorcycle and an
accident.
A
WARNING: Move the handlebars to left
and right full lock while checking that
cables and harnesses do not bind. A cable or
harness which binds will restrict the steering and
may cause loss of control and an accident.
1. Adjuster - Twist Grip End
2. Adjuster - Throttle Body End
13. Set the cable adjuster at the twist grip end such that
it has an equal amount of adjustment in each
direction.
14. Set the adjuster at the throttle body end of the cable
to give 2-3mm of play at the throttle twist grip.
Tighten the locknut.
15. Make any minor adjustments as necessary to give
2-3 mm of play using the adjuster at the twist grip
end of the cable. Tighten the locknut.
A
WARNING: Ensure that the adjuster
locknuts are tightened. A loose throttle
cable adjuster could cause the throttle to stick
leading to loss of control and an accident.
16. Reconnect all remaining electrical connections to
the engine.
(
\
/