Inspection - Triumph Tiger Service Manual

8 LUBRICATION
Inspection
1.
Inspect the oil transfer tube '0' rings for damage
and swelling. Renew as necessary.
2. Inspect the gearbox oil feed pipe '0' ring for damage
and swelling., Renew as necessary.
1
3
2
1. Gearbox Oil Feed Pipe
2. Oil Transfer Tube
3. '0' rings
3.1 nspect the oil pick-up for correctfitment in the lower
crankcase.
Insta"ation
1. Fit the oil transfer tube to the crankcase.
/!gj
1
gajx
1. Transfer Tube Location
2. . Using a new sump gasket, position the sump to the
lower crankcase and locate to the oil transfer tube
and gearbox oil transfer pipe.
8.14
3. Tighten the sump fixings to 12 Nm.
4. Using new sealing washers, reconnect the oil
cooler pipes. Tighten the cooler pipe banjo bolts to
2SNm.
5. Apply a smear of clean engine oil to the seal of a
new oil filter.
6. Fit the oil filter and tighten to
10
Nm using tool
T3880011.
7. Refit the exhaust system as described in the fuel
system section.
NOTE:
•
8.
Use new exhaust gaskets at the downpipe
connections with the cylinder head.
Fill the engine with the correct grade of engine oil
9. Reconnect the battery positive (red) lead first.
10.,
Start the engine and ensure that the low all pressure
warning light goes out shortly after starting.
11.
Stop the engine and adjust the engine oil level.
12. Refit the seats.
(