Getting Started With The Radwin Manager - Radwin 5000 HPMP User Manual

Getting Started with the RADWIN Manager

Getting Started with the RADWIN Manager
We will look at a preconfigured sector, setup as follows:
Table 4-2: Preconfigured setup
Unit Location
HBS HBS_10.200
HSU_10.101
HSU
HSU_10.102
Choose your unit names carefully. For example, for three collocated HBSs
each with 16 HSUs covering 360°, matters get out of hand very quickly if
units are poorly named. They can always be identified by their IP
addresses, but that is a poor substitute for effective naming. A URL-like
naming pattern based on HBS_n.HSU_y is clear and familiar to all Internet
users.
Tip
In a scenario like our example (one HBS, two HSUs) that would have been
be unduly complicated and detracting.

To start the RADWIN Manager:
1. Connect the managing computer to the HBS PoE LAN port.
2. Check that you have connectivity to the HBS ODU. You can do this by opening up a
command line session (Start|Run and then type, cmd). At the command prompt,
type
ping 192.168.10.200
RADWIN 5000 HPMP User Manual
Attribute Value
IP Address 192.168.10.200
Net Mask
255.255.255.0
Default Gateway
0.0.0.0
Sector ID EBG_20560334
Contact Bach
Name Bach's Office
Band 5.730 - 5.845 GHz FCC/IC
Channel Bandwidth 20MHz
IP Address 192.168.10.101
Net Mask
255.255.255.0
Default Gateway
0.0.0.0
Contact Haydn
Name Haydn's Office
IP Address 192.168.10.102
Net Mask
255.255.255.0
Default Gateway
0.0.0.0
Contact Mozart
Name Mozart's Office
Release 3.2.00
Remark
All communicating HSUs and HBS in
the same subnet
Inherited by all communicating HSUs
Optional
Location of Contact - optional
Inherited by all communicating HSUs
Inherited by all communicating HSUs
All communicating HSUs and HBS in
the same subnet
Optional
Location of Contact - optional
All communicating HSUs and HBS in
the same subnet
Optional
Location of Contact - optional
Chapter 4
4-3