Throughput Checking - Radwin 5000 HPMP User Manual

Throughput Checking

The content of the Diagnostics report is an aggregate of all the more specific reports
discussed below. It is primarily intended for use by RADWIN Customer support.
The Spectrum Analysis output is available directly from the Spectrum View
utility as a CSV file (see
is intended for use by RADWIN Customer support.
The Spectrum Analysis section of the Diagnostics report is based on the last
available spectrum analysis (if any). If you are submitting a support request
Note
involving interference issues, or if you are specifically asked by Customer
support to submit a Diagnostics report containing a recent spectrum
analysis, you should carry out the analysis in accordance with the
instructions in
Throughput Checking
In this mode, RADWIN 5000 HPMP estimates Ethernet throughput by filling frames over the
air to maximum for 30 seconds. This mode should not influence service. The test may be car-
ried out for the HBS or an HSU.

To use Throughput Checking:
1. HBS: Chose Estimated Throughput as shown:
HSU from HBS: Chose Estimated Throughput as shown:
HSU direct or over the air: Unavailable.
RADWIN 5000 HPMP User Manual
Chapter 19). The format in the Diagnostics report
Chapter 19 prior to using the Get Diagnostics facility.
Release 3.2.00
Chapter 8
8-4