Configuring False Radar Mitigation - Radwin 5000 HPMP User Manual

Configuring False Radar Mitigation

• Staggered: False radars with variable repetition frequency within a burst period
(Applies to 5.4 GHz ETSI only)
Configuring False Radar Mitigation
The configuration method for the HBS (ETSI and FCC/IC) is the same as for the HSUs (ETSI
only). We will demonstrate the HBS for a sector using the 5.3 GHz FCC/IC band:

To configure False Radar Mitigation:
1. Log on to the HBS as Installer.
2. Enter the Configuration window and open the Advanced tab.
Figure 13-1: False Radar Mitigation
3. The DFS Frequency Status Table at the bottom of
and frequency of the last radars detected. This table should be used to select the
RADWIN 5000 HPMP User Manual
Figure 13-1
Release 3.2.00
Chapter 13
shows the time, type
13-2