Hardware Installation Sequence
•
ODU-PoE cable (outdoor class, CAT-5e, 4 twisted pairs, 24AWG), up to 100 m. for
100BaseT connection. For a 1000BaseT connection (HBS only) use an ODU-PoE cable
no longer than 75m.
For 1000BaseT, you should use RADWIN supplied ODU-PoE cables, which
guarantee 1Gb performance. RADWIN cannot guarantee 1Gb performance
if you use third party cables.
Note
•
A crossed Ethernet LAN cable is required if you set up ODUs using the "Local Connec-
tion" method.
Hardware Installation Sequence
The following steps are required to install a RADWIN 5000 HPMP system:
1. Mounting the ODUs,
2. Mounting the external antennas (if used),
3. Mounting the Lightning Protection devices (if used),
4. Outdoor connections,
5. Connecting the PoEs,
6. Other Indoor connections,
7. Aligning the HSUs to the HBS,
See
Figure 3-10
below, which illustrates a typical installation of a RADWIN 55xx HSU with
an external antenna.
RADWIN 5000 HPMP User Manual
page
3-9.
page
3-10.
page
3-11.
page
3-11.
page
3-11.
Release 3.2.00
page
3-10.
page
3-10.
Chapter 3
3-8