Workflow; Default Radwin 5000 Hpmp Settings - Radwin 5000 HPMP User Manual

Workflow

receives at least one time slot. To disable an HSU you must deregister it. (A suspend mech-
anism is also available, to suspend service on an HSU for a limited period.)
For each registered HSU, you can set separately, the uplink and downlink Maximum Infor-
mation Rate (MIR) in Mbps or leave it at Best Effort.
You may also manage an HSU Connection table to enable and disable connectivity
between HSUs in a sector.
Workflow
In this chapter, we assume that you are familiar with the material of
centrate on setup workflow assuming that you are familiar with GUI.
Prior to commencing, you should have written sector plan along the lines of

Default RADWIN 5000 HPMP Settings

The default settings of the RADWIN 5000 HPMP configuration parameters are listed in
Table 5-1 below.
Table 5-1: Default settings
Unit Parameter
IP Address
Net Mask
Default Gateway
Location
Contact
Name
Factory default band
HBS
Channel Bandwidth
RADWIN Manager log-on
passwords
Observer
Operator
Installer
Link Password
RADWIN 5000 HPMP User Manual
Default Value
10.0.0.120
255.0.0.0
0.0.0.0
Location
Person
Contact
Product dependent
20MHz
admin
admin
wireless
wireless-p2mp
Release 3.2.00
Chapter 5
Chapter 4. We will con-
Table 5-2.
5-2