Power Supply Board : Removal And Installation - MUTOH SC-550 Maintenance Manual

6.3.5. Power supply board : removal and installation.

Note :
This procedure is valid for all SC-series except for SC-550. For the SC-550, please refer
to 6.3.6. Power supply board SC-550.
Step 1 : Open the PCB box (Please refer to 6.2.3.PCB box).
Step 2 : Remove the connectors and the screw from the grounding wire and remove the board.
Note :
To reinstall the board perform above steps in reversed order.
Maintenance Manual – SC Cutting Plotter
64 AP-74030, Rev / B