Adjust. 7; Adjust. 8 - MUTOH SC-550 Maintenance Manual

5.3.6. Diagnost. 6
Reserved for future use.

5.3.7. Adjust. 7

Reserved for future use.

5.3.8. Adjust. 8

1) X-axis Length Adjustment.
* Adjust – 08 *
F3 Xaxis adj
Axis correction
F1 500mm
F3 Robot1
Axis 500mm
F3 Plot
Press (F3) Plot then (F3) start : The plotter will draw a square of 500mm (or 20 Inch).
Remove the paper from the machine and measure the length of the X-axis lines as accurate as
possible.
Press (F4) Input : Now you can enter the real (measured) value.
F1/F3 selects the digit that you want to change.
F2/F4 changes the value.
Press ENTER to confirm.
Press exit.
Caution :
The MUTOH SC-series plotters are calibrated before shipping from the factory. Do
not perform this adjustment except when obviously worsens.
An accurate reference scale is required to perform this calibration.
Roller F4
Press F3
The X-axis length calibration compensates tolerance on the
20inch F2 GRID roller diameters causing incorrect length of the X-axis
Robot2 F4 movement.
Press F1
Load a A1-size paper or a larger and a pen.
Select (F1) or (F2) depending if you want to calibrate metric or
Input F4 imperial.
Maintenance Manual – SC Cutting Plotter
42 AP-74030, Rev / B