Connecting The Power Cable - MUTOH MC series Operation Instructions Manual

Setting up the cutter

CONNECTING THE POWER CABLE

COMMUNICATION SETTINGS
In order for your plotter to be able to communicate well with your host computer, the
communication settings on both machines have to match exactly. Please refer to the
manual of your software to determine which communication settings will be used by your
software. Your cutter is able to be set up to use any settings necessary.
You can proceed in two ways:
• You can check which of the 5 possible defaults matches your software and enable this
particular default setting.
• You can set all communication parameters yourself. In this case, for communication,
select USER DEFINED.
Communication DEFAULT 1
BAUDRATE
DATABITS
PARITY
STOPBITS
SOFTWARE
HANDSHAKE
DTR-Pin
CTS-Pin
RTS-Pin
The factory default settings are shown in Bold-face.
DEFAULT 2
9600 9600
7 8
EVEN NONE
1 1
OFF OFF
ON ON
OFF OFF
ON ON
Operation Instructions MC-Series cutting plotters
1. Make sure the plotter's power switch
is turned OFF.
2. Plug the plotter-end of the power
cable into the connector at the back
of the plotter.
3. Plug the other end of the power cable
into an electrical outlet of the correct
voltage and with a proper grounding.
DEFAULT 3 DEFAULT 4
9600
9600
7
8
EVEN
NONE
1
1
Xon/Xoff
Xon/Xoff
OFF OFF
OFF OFF
ON ON
9
Page
DEFAULT 5 USER
DEFINED
9600 Adjustable
8 Adjustable
EVEN Adjustable
2 Adjustable
OFF Adjustable
ON Adjustable
OFF Adjustable
ON Adjustable
AP-75020, Rev. 1.0 - 18/12/98