Function Keys - MUTOH SC-550 Maintenance Manual

1.3. Function keys.

Using the control panel, you can access different modes and alter several settings, in order to fine-tune the
cutter to match all your needs.
1) JOG – keys
2) ON-LINE
3) ORIGIN
4) PAGE
5) ENTER
6) MENU Selection Keys
7) Value + & - Keys
8) LED indicator for plotter parameters and tool selection indication.
9) LED bar for value indicators, error messages and function confirmation.
10) ONLINE-LED indicator
: Keys for manual movement of the tool head.
: Key to switch between OFF-LINE and ON-LINE mode.
: When this key is pressed, a new origin is set at the present location of
the tool head. Using the ORIGIN key, you can also activate the
alignment function.
: Performs media pre-feed cycle and gives access to the replot / copy
function and starts the automatic sheet-off function.
: To confirm changes and accept settings. The enter key, marked with a
blue dot, also gives access to special functions indicated by the blue text
on the control panel.
: To select the parameter you want to alter.
: To change a parameter's value or setting.
11
Maintenance Manual – SC Cutting Plotter
AP-74030, Rev / B