Eeprom Initialisation And Replacement - MUTOH SC-550 Maintenance Manual

6.3.4. EEPROM initialisation and replacement.

Note :
For EEPROM initialisation see 'Diagnostics with optional LCD keyboard' Diagnostic 1,
memory, EEPROM.
After initialisation or replacement of the EEPROM the following data may be changed and need to be
reinstalled.
Þ
INIT 1 = Settings in normal operation mode = USER parameters such as :
- Speed
- Acceleration
- Force
Offset
-
- Shuffle length
- Tool selection
- Page mode
- Replot factor
Smoothing
-
- Communication parameters
- Command set (language)
Þ
INIT 2 = Adjustments in Diagnostic mode.
X axis length adjustment
-
- Cutting mat height measurement
Knife force calibration
-
- Sheet-off system adjustment (Not for SC-550)
Maintenance Manual – SC Cutting Plotter
63 AP-74030, Rev / B