Electronical Parts; Main Pc Board : Removal And Installation - MUTOH SC-550 Maintenance Manual

6.3. Electronical parts.

6.3.1. Main PC board : Removal and installation.

Note :
This procedure is valid for all SC-series except for SC-550. For the Main PC board SC-
550, please refer to 6.3.2.
Step 1 : Open the PCB box (Please refer to 6.2.3. PCB box).
Step 2 : Unplug all the connectors, remove all screws from the board and remove the board. Do not
forget to remove the screws from the parallel and serial communication connector.
Note :
Pay attention to the position of all connectors and the proper place of all the cables.
This will simplify the installation.
To reinstall the Main PC board perform above steps in reversed order.
Warning :
Check the DIP Switch settings on the board.
The position of the DIP switches determines the type of machine where the board
will be used in. (Please refer to 6.3.3. Dip Switch settings on Main PC board)
Maintenance Manual – SC Cutting Plotter
60 AP-74030, Rev / B