1.2. SC cutting plotter, environment.
The location where you set up your equipment is very important. Please see to it that it meets following
conditions :
Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
q
Ambient conditions :
q
Operating environment
o
§
§
Recommended environment
o
§
§
Variation rate
o
§
§
Storage environment
o
§
Please protect your cutter from moisture, dust, draughts and direct sunlight. It is best to keep
q
your machine away from open windows and air-conditioners.
See to it that there is an adequate space around the cutter so that ventilation is not obstructed.
q
Avoid unnecessary vibrations and set up your cutter on a level surface.
q
When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at the rear.
q
Temperature : 5°C to 40°C (41°F to 104°F)
Humidity : 35% - 75% non-condensation
Temperature : room temperature 16°C to 32°C (61°F to 90°F)
Humidity : 50% to 65% non-condensation
Temperature : 2°C per hour
Humidity : 5% per hour
Temperature : 0°C to 50°C (32°F to 122°F)
Maintenance Manual – SC Cutting Plotter
10
AP-74030, Rev / B