Connecting The Power Cable - MUTOH Ultima 850 Operation Instructions Manual

Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions

2.6. CONNECTING THE POWER CABLE

Step 1 : Make sure the cutter's power switch is turned OFF.
Step 2 : Plug the plotter-end of the power cable into the connector at the rear of the plotter.
Step 3 : Plug the other end of the power cable into an electrical outlet of the correct voltage and with a
proper grounding.
Notes :
The disconnect device is the plug on the power supply cord.
17
AP-75125, Rev 1.3 ; 20/10/04