Free-Exit Opening - Centurion Vector2 User Manual

(adjustable) Autoclose delay will only commence once the beam has
been cleared.
For safety reasons it is recommended that all pedestrian
keyswitches and keypads are installed on the opposite end of
the gate to where the operator is installed
It is possible to adjust the delay before the gate opens in one
second increments from zero to 65 seconds (one minute and
five seconds). The default time is two seconds
It is possible to adjust the width of the pedestrian opening from
a minimum of 50 millimetres to the full gate opening in ten
millimetre increments. The default opening is one metre
It is possible to adjust the delay before the gate closes in one
second increments from zero to 65 seconds (one minute and
five seconds). The default time is five seconds
3.1.5. Free-exit
Opening
The Free-exit Opening allows
visitors to exit townhouses,
estates, factories or office parks
easily.
An inductive ground loop is
mounted under the driveway
inside the property a short
distance away from the gate.
The output of the inductive
ground loop detector is
connected to the free-exit input
on the controller.
When a vehicle drives over the
loop, a detector senses the
metal in the vehicle and
activates the free-exit function
which opens the gate. The
ground loop cannot be activated
by a person or any non-metallic
objects and can be set to only
activate if it detects a large
amount of metal.
Free-exit never initiates a
closing cycle, so the Autoclose
function (page 8) must be
enabled in order for the gate to
close. If the gate is already open or opening, triggering the free-exit
input will have no effect other than to reset the Autoclose timer. If the
gate is closing, triggering the free-exit input will immediately stop and
re-open the gate.
Gate
Vehicle drives over free-exit
inductive loop
Free - exit inductive loop
Free-exit facility activates gate to open
page 11
Inductive loop
FIGURE 9
FIGURE 10
Features
and
functions