Intruder Detection Alarms (A World First); Ambush Alarm; Break-In Alarm - Centurion Vector2 User Manual

3.5. Intruder Detection Alarms* (a world first)

Features
and
functions


3.5.1. Ambush Alarm

Once activated, if the opening
or closing beams are
continuously interrupted for a
predefined time, the Ambush
Alarm will sound. Intruders
often cover beam lenses, thus
breaking the beam, so your
gate stays open after you
have entered or left your
property – but with the
Ambush Alarm enabled you
can be instantly alerted to any
criminal activity.

3.5.2. Break-In Alarm

If the closing beam on the
outside of your property is
broken, the Break-In Alarm
will sound and continue until
30 seconds have passed since
the beam is re-made.
Intruders will not be able to
loiter outside your property as
the Break-In Alarm will
immediately alert you of their
presence – and the noise of
the onboard buzzer is often
an effective deterrent.
Optionally the alarm signal
can be routed to an armed
response company.
If either the Ambush Alarm or Break-In Alarm is utilised, the system
may be configured to operate one of the following outputs provided
on the controller:
 Onboard buzzer – emits a continuous tone
 Pillar / Courtesy light contact
 Safety beam common
 Status LED output
 Auxiliary IO (which can be used to connect to a third party alarm
and security company, or a CENTURION G-SWITCH-22 device to
alert you of the alarm via SMS)
It is typical to select only one of the alarm features.
*Requires infrared gate safety beams to be installed
Intruder masks safety beams,
30 seconds later alarm is activated
Intruder breaks safety beam while
loitering at gate, alarm immediately
activated for 30 seconds
page 18
FIGURE 20
FIGURE 21