Autoclose Mode; Autoclose Override - Centurion Vector2 User Manual

3.1.3. Automatic closing (Autoclose Mode)
The VECTOR2 sliding gate operators have the facility to automatically
close the gate after it has opened. When enabling this feature, the time
that the gate stays open is by default 15 seconds (this time is
adjustable between one and 255 seconds).
As described in the previous section, Autoclose is selectable with
Standard and Reversing Modes (page 6) and by default the function is
off. However, Autoclose is automatically enabled in Condominium Mode.
CENTURION highly recommends that a safety beam is
installed across the gate entrance and connected to the
Closing Safety Beam input on the VECTOR2, if you enable
Autoclose Mode, in order to prevent the gate from closing on
people, pets or vehicles
It is possible to adjust the delay before the gate closes in
one second increments from zero seconds to four minutes.
The default time is five seconds
 3.1.3.1. Autoclose Override
Automatic closing can be
overridden in Standard and
Reversing Modes by pressing and
holding the button of the remote
control or intercom gate release
for no less than three seconds.
The gate response will be to start
opening and then to stop as soon
as the Autoclose Override feature
is activated. On releasing the
button, the gate will continue
opening until fully open.
Your gate will stay open until you
use the remote control or
intercom gate release to close the
gate. The VECTOR2 will then
revert to normal Autoclose
operation.
The Autoclose function cannot be
overridden in Condominium Mode.
It is possible to adjust the
override time or the time
required to hold down the
button in order to override
Autoclose in one second
increments from one to ten
seconds. The default time is
three seconds
Press and hold remote
control pushbutton;
gate will start to open
Gate stops to indicate
that Autoclose Override
has been engaged
Release pushbutton;
gate will continue to open
fully and stay open
page 9
Features
and
functions
FIGURE 6